Q330 From Australia, joined Dec 2003, 1460 posts, RR: 20
Reply 1, posted (10 years 4 months 1 week 6 days 1 hour ago) and read 1987 times:
The first link doesn't work for me, but on the second one I do see just a little bit of compression along the bottom of the fuselage and around the logos. Make sure you save at JPEG quality 12. No reason for the large size either, IMO. I think it would look fine in a smaller size.
Fergulmcc From Ireland, joined Oct 2004, 1916 posts, RR: 52
Reply 2, posted (10 years 4 months 1 week 6 days ago) and read 1970 times:
First Link doesn't work for me either.
Second photo is nice, clear and level. I have an old monitor in work so can't give proper advice but I will say that the photo is a bit big. As Q said, try keeping the ratio of your photo to 4:3 (1024x768).
Kukkudrill From Malta, joined Dec 2004, 1123 posts, RR: 4
Reply 3, posted (10 years 4 months 1 week 5 days 23 hours ago) and read 1956 times:
And remember, every time you save a jpeg it compresses further even at max setting, so work off the original and either make all your changes at one go or save in a different format and reconvert to jpeg at the end. Good luck!
Make the most of the available light ... a lesson of photography that applies to life
Glennstewart From Australia, joined Jun 2003, 1124 posts, RR: 53
Reply 4, posted (10 years 4 months 1 week 5 days 1 hour ago) and read 1909 times:
I can't see the first, but I have a few recommendations for the second.
From a screener's point of view, 1600 pixel wide shots are very hard to accept. They instantly review flaws that the small shots don't.
The acception rate for 1600 pixels wide is far lower than the other resolutions!
The odds are stacked up against you unless the shot is perfect! I highly recommend that you don't upload 1600 pixels wide whatsoever. If you do, reserve it for very special shots where detail might be required.
Other than that, I'm viewing the photo on the LCD screen at work, so it might look worse than it really is (I screen on a really HUGE Sony Trinitron at home - LCD screens are not very good for editing or screening in my opinion).
The res is too large on this monitor for me to see if it's centred or not... (I also screen at 1600x1200). But I can see that the windows are a bit blurry and the nose is a bit blurry.
Borderline for 1600 pixels. But you would have this accepted at 1200 x 800 for example.
Decrease your upload res, and you rejection rate will drop significantly.
Respected users.... If my replies are useful, then by all means...