Spencer From United Kingdom, joined Apr 2004, 1642 posts, RR: 15 Posted (7 years 11 months 1 week 3 days 15 hours ago) and read 4173 times:
I received a colour rejection on the below image. I'm looking for suggestions as to what I could do to improve the COLOURS and/or COLOUR CAST. It's not the greatest scan, I'm only just learning how to scan to tell the truth, so let's keep any suggestions this time to the rejection reason please.
Garry From United Kingdom, joined Feb 2006, 186 posts, RR: 2
Reply 3, posted (7 years 11 months 1 week 3 days 14 hours ago) and read 4154 times:
Hi Spencer - it's not too difficult to remove. The key is getting the Info palette open in Photoshop (assuming you have it)
Here's how I removed it:
Make a threshold layer select white point and black point - you will see when doing this there is a colour cast as the RGB from the Info palette are not equal. Either use Curves or Levels, select white eye dropper and drop it on the white point you found from Threshold. Do same for Black point. This just about removes the cast.
There was also a cast in the mid tones - so I found a neutral gray and again using either Curves or Levels selected the grey/mid eye dropper and selected the point.
The key is making sure when you have a black/white or mid grey the Info palette shows the same values for each of the R, G and B channels.